The present work is to be considered as additional research to the authors' previous studies. It is dedicated to the specification of the significance and impact of certain selected technological parameters on mechanical properties of the composite material based on scrap tyres. The special method what is known as the 'Greece-Latin square' was applied to estimate significance of each technological parameter (input parameter) for selected properties (output parameters) of the material. Moulding pressure (P), formation time (M), polymer binder content (Cpol.) and the size of rubber particles (R) were selected as the input parameters. Compressive modulus of elasticity (Ec), compressive stress at 10% deformation ()10%), permanent deformation after 10% deformation in compressive mode (p) and apparent density (AD) were chosen as the output parameters. An analysis of the obtained dispersion diagrams confirms that composition of the composite material (polymer content) has a greater impact on selected mechanical properties of the material than any other technological input parameter, but apparent density of the composite material demonstrates higher sensitivity to the formation time and moulding pressure of the material than to other input parameters. The obtained results of the experiment enable further optimisation of the composite material production technology and at the same time securing the predictable mechanical properties of the material. 10 Refs.